Xerox Phaser 6120

Disassembly/Assembly Procedures
Phaser® 6120 Color Laser Printer Service Manual
5-37
Density Sensor (AIDC)
1. Remove the Transfer Belt. See Transfer Belt on page 2-12.
2. On the transfer belt, remove two screws [1] and the Density Sensor protective cover [2].
3. Disconnect the connector [3] and remove the Density Sensor [4].
Torque Limiter
1. Remove the Paper Take-up Unit. See Paper Take-Up Unit on page 5-23.
2. Remove the screw [1] and the Paper Take-up Clutch.
3. Disassemble the Paper Take-up Clutch and remove the torque limiter [2].
[2]
[1]
4139fs2061c0
[3] [4]
4139fs2062c0
4139fs2512c0
[1]
[2]