Xerox Phaser 6120 Service Manual

Error Codes and Messages Index
Phaser® 6120 Color Laser Printer Service Manual
4-14
Resetting the Printer:
To reset the printer after a malfunction has occurred, turn the Power Switch OFF, and then ON
again.
24 Fuser Temp Faulty Thermistor
Resistor
The Heater Lamp remains ON for a predetermined
consecutive period of time.
29 Faulty NVRAM counter It is determined that the life counter value is faulty when the
NVRAM data is read as the Power Switch is turned ON.
2A Faulty NVRAM data It is determined that the NVRAM data is faulty when read.
2B NVRAM access failure It is determined that there is a NVRAM data access failure.
2C NVRAM Install failure Mounting of the NVRAM on the Mechanical Control Board
is faulty.
Firmware Update Writing Error
Code Description Detection Timing

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm