Xerox Phaser 6120 Service Manual

Print Engine General Information
Phaser® 6120 Color Laser Printer Service Manual
1-7
Functional Specifications
Warm-up Time
(at ambient
temperature of 23° C/
73.4° F and rated
source
voltage)
110 V to 127 V Average: 52 seconds
220 V to 240 V Average: 55 seconds
System Speed Plain paper 126.78 mm/second
Thick stock 63.39 mm/second
OHP film 42.26 mm/second
First-Page-Out Time
(Plain Paper)
Full Color 1-sided: 22 seconds
2-sided: 35 seconds
Monochrome 1-sided: 13 seconds
2-sided: 26 seconds
Print Speed
(Plain Paper)
Full Color 1-sided: 5 pages/minute
2-sided: 5 pages/minute
Monochrome 1-sided: 20 pages/minute
2-sided: 11.4 pages/minute
Tray Capacities Plain paper and letterhead:200 sheets
Transparencies, thick stock, postcards, labels stock,
and glossy stock:50 sheets
Envelopes:10 sheets
Hard Drive Option 20 GB
Tilt Operating at maximum tilt angle of 2º
Printable Area
(Margins)
Non-printable area: 4 mm (0.16") from edge (top, bottom, left and right) of
listed media sizes except legal size. For Legal size the bottom 16 mm is black
only, color printing area only reach 335.6 mm from top edge.
Side Print Position Accuracy: 4 mm +/- 2.0 mm (0.08 in.)
Top/Bottom Print Position Accuracy: 4mm +/-2.5 mm (0.1 in.)
Skew Simplex Printing A rectangular box of 189 mm by 256 mm will be
used to measure skew.
A . Ve r t i ca l sk ew a < ±2 . 0 mm ( 0. 08 " )
B. Horizontal skew b < ±1.5 mm (0.06")
Duplex Printing (front to
back)
A. Ver t ic al s kew a < 3. 0 m m (0. 12")
B. Horizontal skew b < 2.5 mm (0.10")
Output paper stacking In feeding direction: +/- 9 mm
In side direction: +/- 9 mm
Occasionally, a piece of paper may get pushed out by another paper, this
occurrence rate should be less than 1 for every 50 sheet and less than 50 mm.
The scattering should be tested with either Xerox 4024 75 gsm paper or Xerox
4200 75 gsm paper.
Color Registrations Vertical: Plain paper at all zones; average 0.12 mm
Horizontal: Plain paper at all zones; average 0.12 mm
Print Magnification Vertical (applied to 270.9 mm (10.67 in.) length) < 2.0 mm (0.08") (0.74%)
Horizontal (applied to 184.2 mm (7.25 in.) length) < 1.2 mm (0.05 in.)
(0.65%)

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm