2.17 Braking Resistor Installation
122 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
3. Put the wires through the holes that you cut out of the wiring cover.
A - Wire
Figure 2.136 Lead the Wire through the Wiring Cover
4. Crimp the closed-loop crimp terminal to the wire.
5. Remove the main circuit terminal block nut.
A - Nut
Figure 2.137 Remove the Terminal Block Nut
6. Wire the closed-loop crimp terminal to the main circuit terminal block.
Figure 2.138 Connect the Wire
7. Tighten the nut to the specified torque.
Figure 2.139 Tighten the Terminal Block Nut
To Next Page
Loading...
