Startup Procedure and Test Run
3
3.4 Keypad Operation
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 163
6. Push or to select the backed-up parameter data, then push .
The keypad will show the “End” message when the write process is complete.
Note:
The keypad display differs depending on settings and conditions.
A - A1-02 [Control Method Selection] settings
B - o2-04 [Drive Model (KVA) Selection] settings (2
or 3 digits)
C - Parameter backup data is not registered
D - Backup data does not contain the date
Information
E - Backup date
◆ Verify Keypad Parameters and Drive Parameters
This procedure verifies that the parameter setting values that were backed up in the keypad agree with the
parameter setting values in the drive.
Note:
• Always stop the drive before you start to verify the parameters.
• The drive does not accept Run commands while verifying parameters.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .
To Next Page
Loading...
