YASKAWA CR700

3.4 Keypad Operation
148 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
Note:
You cannot use this function when the keypad is not set to be the Run command source (REMOTE), or when U1-01 [Frequency
Reference] is not shown in the HOME screen.
■ Show the Main Menu
Push to show the main menu. Push (HOME) to return to the HOME screen.
◆ Show the Monitor
This section shows how to show the standard monitors (Ux-xx).
1. Push [Home] to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Monitors], then push .
4. Push or to select [Standard Monitor], then push .
5. Push or to select monitor group, then push .
6. Push or to change the monitor number to show the monitor item.
Note:
Push to go back to the previous page.