EZZ023535
3 / 35
2. Basic Specifications
The CR700 is a drive designed especially for use with cranes. The basic specifications of the
CR700 are based on the information described in the CR700 Technical Manual. Refer to the
CR700 Technical Manual for more information about how to use the keypad and Auto-Tuning.
Precautions before Use
When using the drive with a hoisting and lowering shaft, wire the drive so that hoisting
direction of the machine is the Forward Run command and the lowering direction of the machine
is the Reverse Run command (all control modes). If the movement of the machine and the
direction of the Run commands do not match, the functions and performance of the crane
software will be adversely affected, and it will not be possible to obtain sufficient performance
from the machine. If the direction of motor rotation does not match the machine, swap two
phases of the power lines to the motor and change F1-05 (Encoder 1 Rotation Selection) if the
motor has an encoder to set the hoisting direction of the machine to the Forward Run command
and the lowering direction of the machine to the Reverse Run
command.
Install a fall detector or overspeed detector for safety.
General Safety
• Install a holding brake.
• Implement safety measures such as fall prevention on the machine side.
• Ensure that the holding brake will be applied by an external sequence when there is an
emergency or the power supply is turned OFF.
• Implement a safety circuit that uses the fault relay of this product to apply the holding brake
when a fault occurs.
To Next Page
Loading...
Need help?
General