2.9 Change the Drive Enclosure Type
64 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
A - Front cover B - M4 × 10 truss head screws
Figure 2.63 Install the Front Cover
◆ Attach the Protective Cover (Procedure G)
■ Install the Top Protective Cover
Note:
The appearance is different for different drives, but the installation procedures are the same.
Align the screw holes of the top protective cover with the screw holes on the drive and safety the top protective
cover to the drive with the included screws.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
A - M4 × 10 pan head screws
Figure 2.64 Install the Top Protective Cover
■ Install the Conduit Bracket
• Remove the drive hanging brackets before you install the kit.
• Remove the knock-out holes on the UL Type 1 base before you install it to the drive.
Refer to
Remove the Knock-Out Holes on page 51 for more information.
1. Use the included screws to assemble the stay brackets.
Tighten the screws to a correct tightening torque:
• 1.96 N∙m to 2.53 N∙m (17.35 lbf∙in to 22.39 lbf∙in)
To Next Page
Loading...
