3.7 Test Run Procedure
186 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
◆ Test Run Flowchart
*1 Refer to Brake Sequence on page 195 for details. If you readjust the drive in crane adjustment checks, refer
to
Controllability Problems and Possible Solutions on page 238 for more information.
*2 Refer to
Brake Sequence Checks on page 186 for details. If the adjustment result has a problem, readjust S1-
xx [Brake Sequence].
Figure 3.9 Test Run Procedure
■ Brake Sequence Checks
Perform the following checks when adjusting brake sequences.
• No slipping during startup or stops
• No excessive startup current during startup or stops
Use the following method to quickly determine if there is excessive startup current. Records should usually be
made in charts when performing this check.
To Next Page
Loading...
