Mechanical & Electrical Installation
2
2.9 Change the Drive Enclosure Type
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 61
A - Conduit bracket B - M4 × 8 pan head screws
Figure 2.56 Install the Conduit Bracket
5. Use the included screws to install the front cover to the base.
While slightly lifting the front cover, tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
Note:
The number of screws are different for different models.
• 100-192-121-007: 4 screws
• 100-192-121-008: 6 screws
A - Front cover B - M4 × 10 truss head screws
Figure 2.57 Install the Front Cover
◆ Attach the Protective Cover (Procedure F)
■ Install the Top Protective Cover
Note:
The appearance is different for different drives, but the installation procedures are the same.
Align the screw holes of the top protective cover with the screw holes on the drive and safety the top protective
cover to the drive with the included screws.
Tighten the bolts and screws to a correct tightening torque:
• M10 × 20 hex bolts: 17.65 N∙m to 22.56 N∙m (156.22 lbf∙in to 199.67 lbf∙in)
• M4 × 10 pan head screws: 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
To Next Page
Loading...
