Startup Procedure and Test Run
3
3.4 Keypad Operation
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 151
1. Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push [Back] to show [Home] on .
2. Push [Menu].
3. Push or to select [Monitors], then push .
4. Push or to select [Bar Graph], then push [Setup].
5. Push or to select the location to store the monitor, then push .
6. Push .
7. Push or to select the monitor number to register, then push .
Monitor Set the x-xx part of the Ux-xx. For example, to show monitor U1-01 [Frequency Reference], set it
to "101" as shown in this figure.
The configuration procedure is complete.
To Next Page
Loading...
Need help?
General