YASKAWA CR700

Mechanical & Electrical Installation
2
2.4 Moving the Drive
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 37
3. Prepare the control panel for installation, then lower the drive.
Note:
When lowering the drive, stop before the drive touches the floor, then slowly lower it the remaining distance.
■ Horizontal Suspension
If a horizontal suspension is required in the installation environment, hang the drive through the following steps.
Put the drive on the ground horizontally. Connect wires to the 4 hanging brackets and use a crane to lift the drive.
NOTICE: When you attach a horizontal lifting cable or chain to the drive, use a jig or pad between the wire and the drive. The
wire can scratch the drive and cause damage to the drive.
A - Hanging bracket (4)
Figure 2.6 Horizontal Suspension