YASKAWA NX100 Instructions

4-1
4 Connection
• The system must be grounded.
Failure to ground equipment may result in injury from fire or electric shock.
• Before grounding the system, turn OFF the power supply and lock the
main power switch.
Failure to observe this caution may result in injury and electric shock.
• Do not touch any board inside the controller for five minutes after turn-
ing OFF the power supply.
Capacitors inside the controller store electricity after power is turned OFF. Exercise cau-
tion whenever handling circuit boards. Failure to observe this caution may cause electri-
cal shock.
• Power cannot be turned ON unless the door is closed. Interlocks pre-
vent power from being turned ON.
Failure to observe this caution may result in fire and electric shock.
• Any occurrence during wiring while the NX100 is in the emergency stop
mode is the user’s responsibility. Do an operation check once the wir-
ing is completed.
Failure to observe this caution could lead to injury or mechanical failure.
WARNING

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C