To Next Page

To Previous Page

9.3 Automatic Backup Function

9-17

9.3.3 Loading the Backup Data from the CompactFlash

 Loading Procedure

Restore the backup data saved in the CompactFlash to the NX100 in maintenance mode.

Note that executing "SYSTEM RESTORE" replaces the current CMOS data with the data

of the file "CMOSBK.BIN"

or "CMOSBK??.BIN" (?? denotes figures) in the CompactFlash.

After "CMOSBK.BIN" has been loaded, check if the new data is the same as the previ-

ously saved data in the CMOS, and call the master job to confirm that the current manipu-

lator position is correct and safe. Then, start moving the manipulator.

Operation Explanation

1 Insert the CompactFlash with

the backup data in the Com-

pactFlash slot on the program-

ming pendant.

The backup data is stored under the file name "CMOSBK.BIN" or

"CMOSBK??.BIN" (?? denotes figures.)

2 Turn ON the NX100 power

supply while pressing [MAIN

MENU].

3 Change the security mode to

the management mode.

4 Select {TOOL} under the main

menu.

The sub menu appears.

CAUTION

YASKAWA NX100 Instructions

Other manuals for YASKAWA NX100