YASKAWA NX100 Instructions

5.1 Turning ON the Main Power Supply
5-1
5 Turning ON and OFF the Power Supply
5.1 Turning ON the Main Power Supply
The main power supply is turned ON when the main power supply switch on the front of the
NX100 is turned to the "ON" position, and the initial diagnosis and the current position begin.
Turning ON the Main Power Supply
• Confirm that nobody is present in the P-point maximum envelope of the
manipulator when turning ON the NX100 power supply.
Failure to observe this caution could result in injury caused by accidental contact with the
manipulator.
Press the emergency stop button immediately if any problems occur.
The emergency stop button is located in the upper left of the door on the NX100 and on
the right side of the programming pendant.
WARNING
NX100
Main power supply switch
ON
TRIPPED
RESET
OFF

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C