5.2 Turning ON the Servo Power
5-4
Servo Power ON/OFF --- Enable Switch
When the operator grips the Enable switch, the servo power turns ON. However, if the
operator squeezes the switch until a “click” is heard, the servo power will turn OFF.
When performing emergency stop on the front door of the NX100, programming pendant,
or external signal, the servo power-on operation from the Enable switch is cancelled.
When turning the power back ON, follow the previously listed instructions.
SUPPLE
-MENT
Release -> OFF Squeeze Tightly -> OFFSqueeze -> ON
Servo On
NOTE
To Next Page
Loading...
