YASKAWA NX100 Instructions

6-2
• Perform the following inspection procedures prior to performing teach-
ing operations. If problems are found, correct them immediately, and be
sure that all other necessary processing has been performed.
- Check for problems in manipulator movement.
- Check for damage to the insulation and sheathing of external wires.
• Always return the programming pendant to its specified position after
use.
If the programming pendant is inadvertently left on the manipulator, fixture, or on the floor,
the manipulator or a tool could collide with it during manipulator movement, possibly
causing injuries or equipment damage.
CAUTION

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C