Count... 2 7 Count
...
1. Switch in the Project area to ‘Network view’ .
2. After installing the GSDML the IO device for the SLIO CPU may be found in the
hardware catalog at Other field devices > PROFINET > IO > VIPA GmbH > VIPA
MICRO PLC. Connect the slave system to the CPU by dragging&dropping it from
the hardware catalog to the Network view and connecting it via PROFINET to the
CPU.
3. Click in the Network view at the PROFINET part of the Siemens CPU and enter at
valid IP address data in ‘Properties’ at ‘Ethernet address’ in the area ‘IP protocol’ .
4. Enter at ‘PROFINET’ a ‘PROFINET device name’ . The device name must be
unique at the Ethernet subnet.
5. Select in the Network view the IO device ‘VIPA MICRO PLC’ and switch to the
Device overview.
ð
In the Device overview of the PROFINET IO device ‘VIPA MICRO PLC’ the
CPU is already placed at slot 0.
Connection CPU as
PROFINET IO device
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via Modbus RTU > Usage in Siemens TIA Portal
HB00 | OPL_SP7 | Operation list | en | 18-30 488
To Next Page
Loading...
