YASKAWA VIPA SPEED7 - Page 639

ErrorID Description Remark
0x802E Error command type. Read/write parameter
0x802F No system resources available. Read/write parameter
0x8030 Invalid value at parameter Hardware (1 = SLIO CP; 2 = VIPA CPU). Modbus; Init
0x8031 Invalid value at parameter UnitId. Modbus; Init
0x8032 Invalid value at parameter UserUnitsVelocity (0 = Hz, 1 = %, 2 =
RPM).
Modbus; Init
0x8033 Invalid value at parameter UserUnitsAcceleration (0 = 0.00s, 1 =
0.0s).
Modbus; Init
0x8034 Invalid value at parameter MaxVelocityApp (must be > 0). Modbus; Init
0x8035 Error while read access at MonitorData. Modbus; Init
0x8036 Error while read access at NumberOfPoles. Modbus; Init
0x8037 Error while write access to UserUnitsVelocity. Modbus; Init
0x8038 Error while read access at MinOutputFrequency. Modbus; Init
0x8039 Error while read access at MaxOutputFrequency. Modbus; Init
0x803A Error while write access to StoppingMethodSelection. Modbus; Init
0x803B Error while write access to UserUnitsAcceleration. Modbus; Init
0x8041 Invalid value at parameter AccelerationTime. Modbus V1000
0x8042 Invalid value at parameter DecelerationTime. Modbus V1000
0x8043 Invalid value at parameter JogAccelerationTime. Modbus V1000
0x8044 Invalid value at parameter JogDecelerationTime. Modbus V1000
0x8045 Invalid value at parameter JogVelocity (£ MaxVelocityApp). Modbus V1000
0x80C8 Modbus communication error: No response from the server in the
defined period (timeout can be parametrized via interface).
Modbus V1000
0x809y Error in value of the block parameter y, with y:
n 1: Error in PROTOKOLL
n 3: Error in BAUDRATE
n 4: Error in CHARLENGTH
n 5: Error in PARITY
n 6: Error in STOPBITS
VMC_ConfigMaster_RTU
0x8092 Access error on parameter DB (DB too short). VMC_ConfigMaster_RTU
0x809A Interface not available or used with PROFIBUS. VMC_ConfigMaster_RTU
0x8101 No cyclic communication with axis possible.
0x8102 Command is in current PLCopen-State not allowed.
0x8103 Command is not supported by the axis.
0x8104 Axis is not ready to switch on, possible reasons:
n Communication to the axis is not ready.
n Drive is not in status ‘switched on’ à reset drive error possibly
with MC_Reset.
n Communication was interrupted, e.g. by CPU power cycle.
Reset error with MC_Reset.
PreOperational has also to be set
in Operational.
VIPA SPEED7
Motion control - Simple Motion Control Library
ErrorID - Additional error information
HB00 | OPL_SP7 | Operation list | en | 18-30 639