Zte ZXR10 GER - Chapter 10 Bridge Configuration; Overview; POS Interface Bridge

Confidential and Proprietary Information of ZTE CORPORATION 147
Chapter 10
Bridge Configuration
This chapter introduces the bridging of POS and ATM interfaces,
and relevant configurations on ZXR10 GER.
This chapter covers the following topics.
TABLE 180 TOPICS IN CHAPTER 10
Topic
Page No
POS Interface Bridge 147
ATM Interface Bridge 151
POS Interface Bridge
POS Bridge Overview
Bridge function of the POS interface covers: layer 3 function and
transparent transmission of the bridge interface.
 Layer 3 function of the bridge interface indicates that the PPP
link is directly connected with the Ethernet with BCP
encapsulation. The POS layer 3 interface using BCP
encapsulation can serve as an Ethernet interface and has
attributes of the Ethernet interface, such as ARP learning.
 Transparent transmission function of the POS bridge
interface is implemented through V_Switch functions. With
the V_Switch forwarding table, transparent transmission is
available between the POS interface and the Ethernet and
ATM interfaces.
As a link layer protocol, the PPP is responsible for establishing,
deleting and maintaining layer 2 links. PPP negotiation process is
as follows: LCP negotiationÆEstablish (establish links)ÆCHAP or
PAP authentication.
Introduction
Contents
Layer 3
Function
Link Layer
Protocol