ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
112 Confidential and Proprietary Information of ZTE CORPORATION
2. To create a CPOS interface in T1 encapsulation, use format
tug-2<Vtg number> t1< T1 number > channel-group 1
timeslots <1-24>. Command in interface configuration mode,
as shown in
Table 129.
TABLE 129 T1 ENCAPSULATIONS CPOS INTERFACE
Command
Format
Command
Mode
Command Function
format tug-
2<Vtg
number>
t1< T1
number >
channel-
group 1
timeslots <1-
24>.
Interface
config
This creates a cpos interface in
the T1 encapsulation
Result: This creates a cpos interface in the T1 encapsulation.
3. To set the clock source of T1 channel, use tug-2<Vtg
number> t1< T1 number >clock source command in
interface configuration mode, as shown in
Table 130.
TABLE 130 T1 CLOCK SOURCE COMMAND
Command
Format
Command
Mode
Command Function
tug-2<Vtg
number>
t1< T1
number
>clock
source
Interface
config
This sets the clock source of T1
channel
Result: This sets the clock source of T1 channel.
E
ND OF STEPS
E1 Encapsulation- AU-4
Refer to below procedure for configuring E1 encapsulation in
case of AU-4 on ZTE ZXR10 GER router.
Router Command Line Interface has been accessed.
1. To enter into the tug-3 configuration mode, use au-4 1 tug-
3 command in interface configuration mode, as shown in
Table 131.
Purpose
Prerequisite
Steps
To Next Page
Loading...
