Zte ZXR10 GER - RIP Maintenance & Diagnosis

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
180 Confidential and Proprietary Information of ZTE CORPORATION
RIP Maintenance & Diagnosis
This below procedure describes debugging of Routing
information protocol on ZTE ZXR10 GER router.
 Router Command Line Interface has been accessed.
 Make sure that RIP is running on a network as described in
above basic RIP configurations.
1. To display protocol information, use show ip rip command
in Exec mode as shown in
Table 221.
TABLE 221 SHOW IP RIP COMMAND
Command
Format
Command
Mode
Command Function
show ip rip Exec This displays the basic RIP
running information
Result: This show basic rip routing information.
2. To display rip routing interface and its parameters
information, use show ip rip interface <interface-number>
in Exec mode as shown in
Table 222.
TABLE 222 SHOW IP RIP INTERFACE COMMAND
Command
Format
Command
Mode
Command Function
show ip rip
interface
<interface-
number>
Exec
This displays the current
configuration and status of
an RIP interface
Result: This show rip routing interface information and
parameters.
3. To display the RIP adjacent neighbors, use show ip rip
neighbors command in Exec mode as shown in
Table 223.
TABLE 223 SHOW IP RIP NEIGHBORS COMMAND
Command
Format
Command
Mode
Command Function
show ip rip
neighbors
Exec This displays the information
about all neighbors
configured by the user
Result: This show all the information about RIP neighbors.
4. To display the route item database, use show ip rip
database command in Exec mode as shown in
Table 224.
Purpose
Prerequisites
Steps