Zte ZXR10 GER - Chapter 7; VSwitch Configuration; Configuring VSwitch; Overview

Confidential and Proprietary Information of ZTE CORPORATION 119
Chapter 7
V_Switch Configuration
Overview
This chapter introduces relevant configurations of the V_Switch
on the ZXR10 GER router.
This chapter covers following topics.
TABLE 144 TOPICS IN CHAPTER 7
Topic Page No
V_Switch Overview 119
Configuring V_Switch 119
V_Switch Maintenance and Diagnosis 122
V_Switch Overview
In the “router + BAS” networking, the router serves as two roles:
 Forwarding PPPoE to the BAS equipment
 Implementing data convergence and providing such services
as access (VPN), QoS, NAT and multicast for important
customers.
Therefore, the ZXR10 GER implements layer 2 transmissions of
packets in the static V_Switch transparent transmission mode.
Configuring V_Switch
Refer to below procedure for configuring V_switch on ZTE ZXR10
GER router.
Router Command Line Interface has been accessed.
Introduction
Contents
Purpose
Prerequisite