ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
220 Confidential and Proprietary Information of ZTE CORPORATION
isis metric <metric-value> [level-1|level-2] in IS-IS
interface config mode as shown in
Table 274.
TABLE 274 IS-IS METRIC COMMAND
Command Format
Command
Mode
Command Function
isis metric <metric-
value> [level-
1|level-2]
IS-IS
interface
config
This defines the metric
value of an interface
The <metric-value> ranges from <0-16777214> and divides
into two modes: Narrow mode (0-63); wide mode (0-
16777214).
Result: This configures metric value of an interface.
6. IS-IS configure CSNP interval in order to set the interval
between CSNP packets, use command isis csnp-interval
<num> [level-1|level-2] in IS-IS interface config mode as
shown in
Table 275.
TABLE 275 IS-IS CSNP COMMAND
Command Format
Command
Mode
Command Function
isis csnp-interval
<num> [level-
1|level-2]
IS-IS
interface
config
This defines CSNP packet
sending interval
In a broadcast network, the default value of <num> is 10.
In point to point network default value of <num> is 3600.
Range is from (1-65535).
Result: This configures CSNP packet interval.
E
ND OF STEPS
For More information about IS-IS configuration please follow the
below procedures.
Configuring IS-IS Authentication
ZTE ZXR10 GER supports four types of IS-IS authentication.
Inter-neighbor authentication
Intra-area authentication
Inter-area authentication
Inter-SNP authentication
At present, ZXR10 GER only supports plain text authentication.
This below procedure delivers information about how to do
authentication in IS-IS protocol on ZTE ZXR10 GER.
Related
Information
Overview
Purpose
To Next Page
Loading...
