Zte ZXR10 GER - BGP Maintenance & Diagnosis

Chapter 16 BGP Configuration
Confidential and Proprietary Information of ZTE CORPORATION 231
network 182.16.0.0/16, and R2 will advertise on network
182.17.0.0/16.
BGP Route Advertisement
Refer to below procedure for BGP route advertisement
configuration on ZTE ZXR10 GER.
 Router Command Line Interface has been accessed.
 BGP is running on a network.
1. To advertise network into BGP, use network <ip-address>
<net-mask> command in BGP route mode as shown in
Table
284.
TABLE 284 BGP-NETWORK COMMAND
Command
Format
Command
Mode
Command Function
network
<ip-
address>
<net-
mask>
BGP route
This designates a network table
for BGP routing process
Result: This advertises a network into BGP routing process.
2. Use the redistribute command to redistribute routes
learned by other protocols into BGP route mode which is
shown in
Table 285.
TABLE 285 BGP-REDISTRIBUTE COMMAND
Command
Format
Command
Mode
Command Function
redistribute
<prot-name>
[metric
<value>]
[route-map
<string>]
BGP route
This redistributes routes
obtained by other routing
protocols into BGP routing
table
Result: This command redistributes other routing protocols
into BGP.
redistribute command can redistribute routes of IGPs (RIP,
OSPF and IS-IS) into BGP. Upon the use of the
redistribute command, prevent the redistribution of
routes that IGP learns from BGP into the BGP once again.
Use the filter command to prevent the generation of loops if
necessary.
E
ND OF STEPS
Purpose
Prerequisite
Steps