Zte ZXR10 GER - Diagnosis Mode; Online Help; Available Commands

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
60 Confidential and Proprietary Information of ZTE CORPORATION
To return from the route configuration mode to the global
configuration mode, input the exit command; and to return
from the route configuration mode to the privileged mode
directly, input the end command or press CTRL + Z.
Diagnosis Mode
In the privileged mode, execute the diagnose command to
enter the diagnosis mode, as shown in the following example:
ZXR10#diagnose
Test commands:
ZXR10(diag)#
Diagnosis test commands are provided in the diagnosis mode.
These commands can be used to test cards used in a router,
including bus and connectivity tests. In a diagnosis test, it is
much better not to conduct router configuration.
To return from the diagnosis mode to the privileged mode, input
the exit or end command or press CTRL + Z.
Online Help
Available Commands
In any command mode, enter a question mark (?) after the
prompt of the system, and a list of available commands in the
command mode is displayed. With the context-sensitive help
function, the keywords and parameter lists of any command can
be obtained.
Refer to below procedure for taking online help regarding the
router CLI commands.
Router command Line Interface has been accessed.
1. To take help in any command mode, enter a question mark
"?" after the prompt of the system as shown below
Diagnose
Command
Background
Purpose
Prerequisite
Steps