Zte ZXR10 GER - Command Function; IGMP Maintenance and Diagnosis; Mode as Shown in Table 416

Chapter 24 Multicast Routing Configuration
Confidential and Proprietary Information of ZTE CORPORATION 351
3. To show the information about the multicast reverse path
forwarding (RPF), use show ip rpf <source-address>
command in Priviliged mode as shown in
Table 415.
TABLE 415 SHOW IP RPF COMMAND
Command
Format
Command
Mode
Command Function
show ip rpf
<source-
address>
Privileged This shows the information
about the multicast reverse
path forwarding (RPF)
Result: This shows the information about the multicast
reverse path forwarding (RPF).
E
ND OF STEPS.
IGMP Maintenance and Diagnosis
Below procedure gives information about IGMP maintenance &
diagnosis.
Router CLI (Privileged Mode) has been accessed.
ZXR10 1800/2800/3800 Router provides some commands to
show the IGMP status. The following are some common
commands:
1. To view the IGMP information on an interface, use show ip
igmp interface [<interface-name>] command in Priviliged
mode as shown in
Table 416.
TABLE 416 SHOW IP IGMP INTERFACE COMMAND
Command
Format
Command
Mode
Command Function
show ip
rpf
<source-
address>
Privileged
This shows the IGMP information
on an interface
Result: This shows the IGMP information on an interface.
Example: This shows the IGMP information of the fei_1/1
interface.
Purpose
Prerequisites
Steps