ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
348 Confidential and Proprietary Information of ZTE CORPORATION
According to the configured ACL rules, only the (S, G)
multicast routing entries that meet such rules can occur in
the SA message generated by a MSDP neighbor.
2. To set to filter the SA message from a designated MSDP
neighbor, use ip msdp sa-filter in <peer-address> [list
<acl-number>] command in global configuration mode as
shown in
Table 407.
TABLE 407 IP MSDP SA-FILTER IN COMMAND
Command
Format
Command Mode Command Function
ip msdp
redistribute [list
<acl-number>]
Global
configuration
This sets to filter the
SA message from a
designated MSDP
neighbor
Result: This sets to filter the SA message from a designated
MSDP neighbor.
3. To set filter the SA message sent to a designated MSDP
neighbor, use clear ip msdp peer [<peer-address>]
command in global configuration mode as shown in
Table
408.
TABLE 408 IP MSDP SA-FILTER OUT COMMAND
Command
Format
Command Mode Command Function
clear ip msdp
peer [<peer-
address>]
Global
configuration
This set filter the SA
message sent to a
designated MSDP
neighbor
Result: This set filter the SA message sent to a designated
MSDP neighbor.
E
ND OF STEPS
Clearing the MSDP Status
This topic describes how to clear the MSDP status
Router CLI (Privileged Mode) has been accessed.
1. To clear the TCP connection with all/designated MSDP
neighbors, use clear ip msdp sa-cache [<group-address>]
command in Priviliged mode as shown in
Table 409.
Purpose
Prerequisites
Steps
To Next Page
Loading...
