ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
48 Confidential and Proprietary Information of ZTE CORPORATION
FIGURE 35 ZXR10 GER CONFIGURATION MODE
ZXR10
TFTP/FTP/Radius server
Telnet/SSH host SNMP NMS
Hyper terminal
COM interface
Configuring COM Port
This topic describes how to configure ZXR10 GER using COM
port.
Command Line Interface (CLI) is accessed.
Note: CLI is a text-based interface that can be accessed
through a direct serial connection to device and through telnet
connections. For serial connection, there must be a DB-9 serial
cable connected between Computer System and Router.
Proceed with the following steps.
1. Click on Start>Programs>Accessories>Communications
> HyperTerminal
2. Click on HyperTerminal and then, type ZTE as connection
name and then click> OK button, as shown in
Figure 36.
Purpose
Prerequisite
Steps
To Next Page
Loading...
