Zte ZXR10 GER - Router Operating System; Technical Features and Parameters

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
6 Confidential and Proprietary Information of ZTE CORPORATION
Router Operating System
ZTE has developed Router Operating System (ZXROS) for its
carrier class routers. ZTE completely owns the self-proprietary
rights of ZXROS. ZXROS is used in ZXR10 GER.
ZXR10 GER supports industry standard protocols. These
protocols are given below:
Industry Standard Protocols
Link-layer protocol: PPP, MPPP , VLAN TRUNK, HDLC and FR
Network-layer protocol: IP, ICMP, ARP, V-SWITCH and SMARTGROUP
Transmission-layer protocol: TCP and UDP
Routing protocol: RIP v1/v2, OSPF v2, BGP4 , integrated IS-IS,
RIPng，OSPFv3，ISISv6 and BGP4+
MPLS/VPN, VPWS, QOS, TE, policy routing and load sharing
Tunnel protocol: GRE 6in4 tunnel,6to4 tunnel,4in6 tunnel
Application-layer protocol: Telnet, FTP and TFTP
Network-layer control application: NAT, ACL and URPF
NM protocol: SNMP v1/v2/v3, RMON v1 and NTP
Technical Features and Parameters
ZXR10 GER follows IEEE standard:
Q/SZX 122-2002 ZXR10 middle/low-end router
Table 4 shows ZXR10 GER technical features and parameters.
TABLE 4 TECHNICAL FEATURES AND PARAMETERS
Item Specification
Processor specification Dedicated network processor
SDRAM configuration 256M~512M, 512M by default
SRAM configuration 8 M
FLASH configuration 64 M
Number of available slots 8
Basic configurations 1COM and 1FE
Bus bandwidth 32 Gbps
Message processing capability 24Mpps
Number of routing entries 200K
Routing protocols supported
RIP v1/v2, OSPF, BGP4 and
integrated IS-IS
Background
Supporting
Protocols
Standard
Features