Zte ZXR10 GER - Configuring IGMP Timer

Chapter 22 VPLS Configuration
Confidential and Proprietary Information of ZTE CORPORATION 315
FIGURE 109 VPLS SERVICE
Fei_1/2
Fei_3/1
Fei_2/1
Fei_2/2
Fei_4/
1
Fei_1/1
Fei_3/2
Fei_5/1
PE1 P PE2
CE1
CE2
CE3
Fei_6/1
Fei_3/3
PE1 configuration:
PE1(config)#vfi vpls_a
PE1(config-vfi)#vcid 100
PE1(config-vfi)#pwtype Ethernet
ZXUAS(config-vfi)#mac-timeout 180
PE1(config-vfi)#peer 1.1.1.3
PE1(config-vfi)#maxmac 1000
PE1(config-vfi)#exit
PE1(config)#bras
ZXUAS(config-bras)#vfi account-group 100 /*configure VFI
account*/
PE1(config)#interface loopback10
PE1(config-if)#ip address 1.1.1.1 255.255.255.255
PE1(config)#interface fei_1/1
PE1(config-if)#xconnect vfi vpls_a
PE1(config-if)#mac-limit 100 /* set the max munber of
MAC address */
PE1(config)#interface fei_1/2
PE1(config-if)#ip address 175.1.1.1 255.255.255.0
PE1(config-if)#mpls ip
PE1(config-if)#client-interface /* S
e
t the interface
worked at client mode in hub-spoke network */
PE1(config)#mpls ip
PE1(config)#mpls ldp router-id loopback10 force
PE1(config)#mpls ldp target-session 1.1.1.3
PE1(config)#router ospf 1
PE1(config-router)#network 1.1.1.1 0.0.0.0 area 0.0.0.0
PE1(config-
r
outer)#network 175.1.1.0 0.0.0.255 area
0.0.0.0
P configuration:
P(config)#interface loopback10
P(config-if)#ip address 1.1.1.2 255.255.255.255