Zte ZXR10 GER - Page 336

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
314 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 359 PEER COMMAND
Command Format Command Mode
Command
Function
peer {<peer-router-
id> ＜-1024＞|spoke
＜1-1024}＞
VFI This creates peer
Result: This creates Peer.
6. To set the max number of MAC address, use command
maxmac in VFI configuration mode. This is shown in
Table
360.
TABLE 360 MAXMAX COMMAND
Command
Format
Command
Mode
Command Function
maxmac VFI
This sets the max number of MAC
address
Result: This sets the max number of MAC address.
7. To configure ldp neighbor, use command mpls ldp target-
session <ip-address> in global configuration mode. This is
shown in
Table 361.
TABLE 361 MPLS LDP TARGET COMMAND
Command
Format
Command
Mode
Command Function
mpls ldp
target-
session
<ip-
address>
global config This configures ldp neighbor
Result: This configures ldp neighbor.
E
ND OF STEPS
Example:
Create VFI，and configure the parameters such as vcid 、pwtype
and peer. Configure the loopback at PE1、P and PE2. Run the
IGP protocol such as OSPF protocol between PE1、P and PE2.
Enable mpls in the global configuration mode, this also needs to
enable on interface such as fei_1/2 at PE1, fei_2/1 and fei_2/2
at P, fei_3/1 at PE2.
Configure target-session in PE1 and PE2， make PE1 and PE2
became neighbor. Enable the vpls service in the interface fei_1/1
at PE1, fei_3/2 and fei_3/3 at PE2. This is shown in
Figure 109.