Zte ZXR10 GER - MPLS Configuration

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
278 Confidential and Proprietary Information of ZTE CORPORATION
MPLS Configuration
Refer to below procedure for MPLS configuration on ZTE ZXR10
GER.
Router Command Line Interface has been accessed.
1. Enter into configuration mode by writing config terminal
command in global configuration mode as shown in
Table
321.
TABLE 321 CONFIG TERMINAL COMMAND
Command
Format
Command
Mode
Command Function
config
terminal
Global
Enters into global configuration
mode
Result: This enables to enter into global configuration mode.
2. To enable LDP to set up an LSP along a common hop-by-hop
routing path, use mpls ip command in global configuration
mode as shown in
Table 322.
TABLE 322 MPLS IP COMMAND
Command
Format
Command
Mode
Command Function
mpls ip global config
This enables LDP to set up an
LSP along a common hop-by-
hop routing path
Result: This enables LDP to set up an LSP along a common
hop-by-hop routing path.
3. To enable LDP label switching on the interface, use mpls ip
command in interface configuration mode as shown in
Table
323.
TABLE 323 MPLS IP COMMAND
Command
Format
Command
Mode
Command Function
mpls ip
interface
config
This enables LDP label switching
on the interface
Result: This enables LDP label switching on the interface.
4. To configure the transport address parameter contained in
the Hello message, use mpls ldp discovery transport-
address {interface|<ip-address>} command in interface
configuration mode as shown in
Table 324.
Purpose
Prerequisite
Steps