Zte ZXR10 GER - Page 301

Chapter 19 MPLS Configuration
Confidential and Proprietary Information of ZTE CORPORATION 279
TABLE 324 MPLS LDP DISCOVERY COMMAND
Command
Format
Command
Mode
Command Function
mpls ldp
discovery
transport-
address
{interface|<ip-
address>}
interface
config
This configures the transport
address parameter contained
in the Hello message
Result: This configures the transport address parameter
contained in the Hello message.
Note:
By default, ZXR10 GER regards the router ID on an interface
in frame mode as transport address and advertises the
address in Hello message. Above command can change
default behavior of router on an interface.
If parameter interface is used, the LDP will advertise the IP
address of the interface in the Hello message of the interface.
If parameter <ip_address> is used, LD will advertise
designated IP address in Hello message on the interface.
5. To designate the IP address of an interface as the router ID
of the LDP, use mpls ldp router-id <interface-number>
[force] command in global configuration mode as shown in
Table 325.
TABLE 325 MPLS LDP ROUTER-ID COMMAND
Command
Format
Command
Mode
Command Function
mpls ldp
router-id
<interface-
number>
[force]
global config
This designates the IP address
of an interface as the router ID
of the LDP
Result: This designates the IP address of an interface as the
router ID of the LDP.
6. To control the LDP to create the FEC item (that is, FEC
filtering policy) for which destination network sections, use
mpls ldp access-fec {for <prefix-access-list>|host-route-
only} command in global configuration mode as shown in
Table 326.
TABLE 326 MPLS LDP ACCESS-FEC COMMAND
Command
Format
Command
Mode
Command Function
mpls ldp
access-fec
{for <prefix-
access-
global config
This configures FEC filtering
policy