Zte ZXR10 GER - MSDP Policy Configuration

Chapter 24 Multicast Routing Configuration
Confidential and Proprietary Information of ZTE CORPORATION 347
TABLE 404 IP MSDP SA-LIMIT COMMAND
Command
Format
Command
Mode
Command Function
ip msdp
originator-
id
<interface-
name>
Global
configuration
This limits the number of SA
messages from the designated
MSDP neighbor in the SA cache
table
Result: This limits the number of SA messages from the
designated MSDP neighbor in the SA cache table.
4. To limit the scope of the MSDP neighbor to which the
multicast packets encapsulated into the SA packets to be
sent, use ip msdp ttl-threshold <peer-address> <ttl-
value> command in global configuration mode as shown in
Table 405.
TABLE 405 IP MSDP TTL-THRESHOLD COMMAND
Command
Format
Command Mode Command Function
ip msdp ttl-
threshold
<peer-address>
<ttl-value>
Global configuration This limits the scope
of the MSDP neighbor
to which the multicast
packets encapsulated
into the SA packets to
be sent
Result: This limits the scope of the MSDP neighbor to which
the multicast packets encapsulated into the SA packets to be
sent.
MSDP Policy Configuration
This topic describes how to configure MSDP policy.
Router CLI (Privileged Mode) has been accessed.
1. To limit generation of the SA message, use ip msdp sa-
filter in <peer-address> [list <acl-number>] command in
global configuration mode as shown in
Table 406.
TABLE 406 IP MSDP REDISTRIBUTE COMMAND
Command
Format
Command Mode Command Function
ip msdp sa-
filter in <peer-
address> [list
<acl-number>]
Global
configuration This limits generation of
the SA message
Result: This limits generation of the SA message.
Purpose
Prerequisites
Steps