EasyManua.ls Logo

Zte ZXR10 GER - Configuring IGMP

Zte ZXR10 GER
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 22 VPLS Configuration
Confidential and Proprietary Information of ZTE CORPORATION 313
1. To create VFI, use command vfi<vfi-name> in global
configuration mode. This is shown in
Table 355.
TABLE 355 VFI COMMAND
Command
Format
Command
Mode
Command Function
vfi<vfi-
name>
global config This creates VFI
Result: This creates VFI.
2. To enable MPLS, use command mpls ip in global
configuration mode. This is shown in
Table 356.
TABLE 356 MPLS ID COMMAND
Command
Format
Command
Mode
Command Function
mpls ip global config This enables MPLS
Result: This enables MPLS.
3. To create VCID, use command vcid <vcid-number> in VFI
configuration mode. This is shown in
Table 357.
TABLE 357 VCID COMMAND
Command
Format
Command
Mode
Command Function
vcid
<vcid-
number>
VFI This creates VCID
Result: This creates VCID.
4. To configure PWTYPE, use command pwtype
<ethernet|ethernet-vlan> in VFI configuration mode. This is
shown in
Table 358.
TABLE 358 PWTYPE COMMAND
Command Format
Command
Mode
Command Function
pwtype
<ethernet|ethernet-
vlan>
VFI This configures PWTYPE
Result: This configures PWTYPE.
5. To create peer, use command peer {<peer-router-id> -
1024|spoke 1-1024} in VFI configuration mode. This
is shown in
Table 359.

Table of Contents

Related product manuals