EasyManua.ls Logo

Zte ZXR10 GER - Page 142

Zte ZXR10 GER
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
120 Confidential and Proprietary Information of ZTE CORPORATION
1. To configure the forwarding mode of an interface, use ip
forwarding-mode command in interface configuration
mode, as shown in
Table 145.
TABLE 145 IP FORWARDING MODE
Command
Format
Command
Mode
Command Function
ip
forwarding-
mode
Interface
config
This configures the forwarding
mode of an interface
Result: This configures the forwarding mode of an interface.
.2. To configure the forwarding table of the V_Switch, use vlan-
forwarding ingress command in interface configuration
mode, as shown in
Table 146.
TABLE 146 VLAN FORWARDING INGRESS
Command
Format
Command
Mode
Command Function
vlan-
forwarding
ingress
Interface
config
This configures the forwarding
table of the V_Switch
Result: This configures the forwarding table of the V_Switch.
E
ND OF STEPS
Example:
The following takes the Ethernet interface as an example to
introduce V_Switch configuration. For detailed V_Switch
transparent transmission configurations of the POS and ATM
interfaces, refer to “
Chapter 10
Bridge Configuration”. As shown in
Figure 71, the fei_1/3
interface of the ZXR10 GER is connected to the user side of the
BAS and the fei_1/4 interface is connected to the network side
of the BAS.
The fei_1/3 interface of the ZXR10 GER connects PPPoE users
and the fei_1/2 interface connects dedicated line users. The
VLAN ID range of PPPoE users is 10~19. The corresponding
VLAN ID range at the user side of the BAS is 20~29 and that of
dedicated line users is 30~31.
Steps
Introduction
PPPoE
Connection

Table of Contents

Related product manuals