6-18 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Calibration Chapter 6
The [CHANGE SAMPLER] key is used to change the sample
aspiration mode of the Analyzer from the currently selected mode that is
indicated on the screen.
The [RETURN] key is used to return to the CALIBRATION MENU
Screen.
The [WHOLE BLOOD] key is used to display the WHOLE BLOOD
AUTO-CAL Screen (Figure 6.6). This screen accesses the Auto-Cal
program that is used to calibrate the instrument with fresh Whole Blood
Samples. The WHOLE BLOOD AUTO-CAL Screen and the following
soft key labels are displayed:
EDIT REF VAL
START AUTO-CAL
QUIT AUTO-CAL
CLEAR REF VALS
PRINT SUMMARY
RETURN
CONFIRM SELECTION (This key appears only if
Auto-Cal was last performed
with a Calibrator.)
CANCEL SELECTION (This key appears only if
Auto-Cal was last performed
with a Calibrator.)
These keys are used to confirm or cancel the Whole Blood Auto-
Cal selection.
The bulletin line displays the message:
PRESS CONFIRM SELECTION TO CLEAR PREVIOUS
AUTO-CAL REFERENCE VALUES.
The [EDIT REF VAL] key is used to edit the displayed reference value
indicated by the position of the cursor. The key deletes the existing value
and the cursor remains in position for the new entry.
CHANGE
SAMPLER
RETURN
WHOLE
BLOOD
EDIT
REF VAL
To Next Page
Loading...
