Service Manual – Periodic maintenance
SERVICE MANUAL • X-MIND prime 3D • (19) • 11/2019 • NXMPEN080A
The appliance’s performance is checked and, where necessary corrected, during
the maintenance activities performed by the Technical Service Department, in
accordance with the indications provided in the following chapters.
The periodic maintenance performed by the Technical Service Department
comprises the performance of the following additional inspection activities:
General visual inspection
Grounding of all the conductive parts and
cables
Condition of the internal and external cables:
wear and tear and fastenings
Visual and practical
inspection
Tightening of the primary bolts and screws
such as the wall fastening systems, the
moving mechanisms and the chin rest arm
Correct equipment centring
See paragraphs
7.10 and 7.11
See paragraphs
7.13.1 and 7.13.2
Perform sensor calibration
Warning
Only use original spare parts if components need to be replaced.
The relevant replacement instruction is supplied with the spare part.
Note
The Service Engineer has to take special care for all what concerns electrical
safety of the device and must make sure of restoring all provisions for
electrical safety which may be affected during a service intervention and to
solicit the customer to have the electrical safety tests repeated every time
the intervention has caused the replacement of important parts or the
intervention has significantly affected safety provisions of the device.
Note
Interventions carried out by the Service Engineer must be noted in the
Maintenance Record page at the end of the User Manual, with a short
description of the actions done.
To Next Page
Loading...
