Acteon X-MIND prime 3D ceph - Errors with Code from E1201 to E1205; Errors with Code from 1401 to 1405

Service Manual – Troubleshooting
SERVICE MANUAL • X-MIND prime 3D • (19) • 11/2019 • NXMPEN080A
195
9.2.9 Error with code from E1201 to E1205
These errors are related to the system PC software application issues or the
communication with unit’s boards.
9.2.9.1 E1201: Failed to write data in EEPROM from Setup menu /
E1203: Error detected in software allocation
These messages are displayed when a software error has been detected.
If the error is displayed, contact Technical Service.
Technical Service additional information required :
- Condition/unit state/sequence in which the error occurs/can be reproduced
- Software logs (see paragraph 11.2.1).
9.2.9.2 E1202: Unexpected value encountered by the software /
E1204: Error detected in exposition parameters /
E1205: Error detected in image buffer allocation
These messages are displayed when a Software or Firmware error has been
detected.
If the error is displayed, contact Technical Service.
Technical Service additional information required :
- Software logs (see paragraph 11.2.1).
9.2.10 Error with code from 1401 to 1405
9.2.10.1 E1401: Sensor connection lost during the exam /
E1405: Sensor frame lost during exam