Service Manual – Pre-installation
SERVICE MANUAL • X-MIND prime 3D • (19) • 11/2019 • NXMPEN080A
Note
A shock detector is applied to the packaging.
Upon receipt of the unit, check that the sensor has not been activated.
In case the sensor has been activated, immediately notify the forwarder
and sign the delivery note as “Provisionally accepted”.
Warning
Acteon will not bear any responsibility for damages caused to the
equipment due to improper unpackaging procedure, and for the relevant
costs.
Note
The package will be used as a tool during the initial steps of the installation.
Do not discard the packaging until installation has been completed and unit
is fully operational.
To Next Page