ADCMT 6240B User Manual

6240B DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-25
Source Source range SIRX Optimal range
SIR-1 30 µA range
SIR0 300 µA range
SIR1 3 mA range
SIR2 30 mA range
SIR3 300 mA range
SIR4 1A range
SIR5 4 A raneg
SIR? Response: SIRX-1 to SIRX5 (for the optimal range)
SIR-1 to SIR5 (for the fixed range)
Source value SOV data Voltage source value setting
0
SOI data Current source value stting
0
SOV? Response: SOV ± d.ddddE d
*1, *2
SOI? SOI  d.ddddE  d
Spot command G data Executes the measurement trigger after setting the
source value for the currently set source function.
Limit value LMV
data1
[,data2]
Voltage limit value setting
15 V
LMI
data1
[,data2]
Current limit value setting
1 A
Both the HI and LO limit values can be set.
- In comparison between data1 and data 1, the larger
value is the HI limit value and the smaller one is the
LO limit value.
- data 2 can be omitted. In this case, +data1 and -data
1 are assumed as HI and LO limit values respec-
tively regardless of the data1 polarity.
LMV? Response: LMV  <hl>,  <ll>
*1
LMI? LMI  <hl>,  <ll>
*1
hl : <d.dddE  d> (High limit value)
ll : <d.dddE  d> (Low limit value)
*1
*1: The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
*2: Outputs the value that is currently generated or the value that is generated during Operate.
Item Command Description
Default Operation
Power ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS
Note:
1. LM1 data1 and data 2 cannot be set homopolar.
2. Set the difference between the HI and LO limit values to
60 digits or more.

ADCMT 6240B Specifications

General

Brand	ADCMT
Model	6240B
Category	Measuring Instruments
Language	English