ADCMT 6240B User Manual

6240B DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-36
System Synchronous con-
trol signal I/O set-
ting
CP0 COMPLETE signal output Meas Front (measurement
start)
CP1 COMPLETE signal output Meas End (measurement
end)
CP2 COMPLETE signal output Comp HI
(Comparator calculation result: HI)
CP3 COMPLETE signal output Comp GO
(Comparator calculation result: GO)
CP4 COMPLETE signal output Comp LO
(Comparator calculation result: LO)
CP5 COMPLETE signal output Comp HI or LO
(Comparator calculation result: HI or LO)
CP6 Sync Out signal output
CP? Response: CP0 to CP6
CW0 Specifies the synchronous control signal output width:
10 µs
CW1 Specifies the synchronous control signal output width:
100 µs
CW? Response: CW0 or CW1
GPIB Block delimiter DL0 CRLF<EOI>
*5
*8
DL1 LF
DL2 <EOI>
DL3 LF<EOI>
DL?
Response: DL0 to
DL3
Header OH0 OFF
OH1 ON
*6
OH? Response: OH0 or OH1
*5: Not initialized by the RINI command.
*6: Not initialized by the RINI or *RST command.
*8: EOI is a GPIB function and cannot be output by USB.
Item Command Description
Default Operation
Power ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS

ADCMT 6240B Specifications

General

Brand	ADCMT
Model	6240B
Category	Measuring Instruments
Language	English