Adva FSP 3000R7 - Verifying OSPF Neighbors

Troubleshooting Control Plane Issues
Verifying OSPFNeighbors
Verify all OSPFneighbors are correctly discovered, as described in the following
procedure.
Step 1 Select System Management > System OSPF Settings > OSPF Neighbors.
The OSPF Neighborswindow displays this NE's OSPFneighbors.
+------------------------------ OSPF Neighbors -------------------------------+
| |
| Interface IP Adj State Adj Role Node IP Node TID |
| +-------------------------------------------------------------------------+ |
| |172.18.32.72 2WAY OR 172.18.32.72 node72 | |
| |172.18.32.73 2WAY OR 172.18.32.73 NODE73 | |
| |172.18.32.86 2WAY OR 172.18.32.86 node86 | |
| |172.18.32.87 2WAY OR 172.18.32.87 node87 | |
| |172.18.36.1 2WAY OR 172.18.36.1 HUB1 | |
| |172.18.36.2 2WAY OR 172.18.36.2 ILA1 | |
| |172.18.36.3 2WAY OR 172.18.36.3 ILA2 | |
| |172.18.36.4 2WAY OR 172.18.36.4 ILA3 | |
| |172.18.36.5 FULL DR 172.18.36.5 ILA4 | |
| |172.18.36.6 FULL BDR 172.18.36.6 HUB2 | |
| | | |
| | | |
| | | |
| +-------------------------------------------------------------------------+ |
| |
| [ Back ] [ Refresh ] [ Top ] [ Bottom ] [ Page Up ] [Page Down] |
| |
Step 2 Refer to your DCNplan to ensure all nodes designated as this NE's
OSPFneighbors are listed in the table.
Step 3 If any OSPFneighbors are absent from this table, check the
OSPFconnectivity between the corresponding nodes.
Note
If OSPFis used by external DCNs, the Adj field should not be set to
DRor BDR.
FSP 3000R7 Maintenance and Troubleshooting Manual - Product Release 16.2 - Document Issue A 565