Adva FSP 3000R7 - ASETAB-NA (ASE Table-Not Available); ASETABUILD (ASE Table-Build); AUTHPW-MIS (Authentication Required)

Standing Conditions
ASETAB-NA (ASE Table-Not
Available)
The corresponding SNMP name for this condition is “aseTableNotAvailable”.
AIDTYPE Default
Severity
Probable Cause Suggested Corrective Action
OM:
RAMAN
CR The amplifier module
has not had the ASE
table build process
performed successfully.
Perform the ASE table build
process on the amplifier module
(e.g. the OPR-ASETBL-OM
command in TL1).
Table 139: ASETAB-NA (Standing Condition)
ASETABUILD (ASE Table-Build)
The table below lists causes and corrective actions for the “amplified spontaneous
emissions (ASE) table build in progress” (ASETABUILD) standing condition.
The corresponding SNMP name for this condition is “aseTableGenProgress”.
AIDTYPE Default
Severity
Probable Cause Suggested Corrective Action
OM:
RAMAN
NA The amplifier module
ASE table build
process is in
progress.
This condition is informative and
requires no corrective action.
Table 140: ASETABUILD (Standing Condition)
AUTHPW-MIS (Authentication
Required)
The corresponding SNMP name for this condition is
“encryptionPortAuthPasswdMissing”.
AIDTYPE Default
Severity
Probable
Cause
Suggested Corrective Action
CH MN An
authentication
key is not
provisioned.
Cryptographic services require that both
ends of a circuit be provisioned with the
same secret key value (the authentication
key).
1 Provision the same authentication key
value at both ends of the circuit.
2 Manually initiate negotiation of the
session key to activate encrypted
service.
Table 141: AUTHPW-MIS (Standing Condition)
802 FSP 3000R7 Maintenance and Troubleshooting Manual - Product Release 16.2 - Document Issue A