Adva FSP 3000R7 - SGEO-CPORT (C Port Outage); SGEO-CPORT (Standing Condition)

Standing Conditions
SGEO-CPORT (C Port Outage)
The corresponding SNMP name for this condition is “lossOfSignalCPort”.
AIDTYPE Default
Severity
Probable
Cause
Suggested Corrective Action
CH NR The signal
arriving on the
client port which
is cross
connected to the
facility has
failed.
1 Verify that the facility is correctly
cross-connected to the intended
incoming signal.
2 Verify that the incoming cable of the
relevant cross connected facility is
the correct cable and that the transmit
and receive ports are connected to
their proper respective portions of the
cable (i.e. that the fibers are not
swapped between transmit and
receive).
3 Verify that the incoming optical cable
is firmly connected to the receive port
associated with the relevant cross
connected facility and that the
connector is not physically impaired
by obstructions, dirt or component
damage. Clean the connector or
replace the cable, plug or module, as
appropriate, depending upon the
cause determined from the physical
examination.
4 Verify that the incoming signal
conforms to the required
specifications (e.g. maximum power
levels). If the signal meets the
required specifications proceed to the
next step below, otherwise locate the
source of the signal problem
upstream and repair the problem.
5 Replace the module supporting the
facility.
Table 387: SGEO-CPORT (Standing Condition)
FSP 3000R7 Maintenance and Troubleshooting Manual - Product Release 16.2 - Document Issue A 971