Adva FSP 3000R7 - Configuring Wavelengths; Reconfiguring Wavelengths

Configuring Wavelengths
Configuring Wavelengths
Some modules feature a network interface that is fully tunable from channel #D01 up to
channel #D32, including #DC1 to #DC9, in a wavelength grid of 100 GHz. Each channel
can be tuned by using the NE management tools.
This section describes how to configure a channel on a tunable network interface.
This section contains the following subsection:
“Reconfiguring Wavelengths” on p.593
Step 1 Select .
Step 2 In the Navigation Tree, select Shelf > Channel module slot.
This channel is unassigned and must now be created.
Step 3 Expand the Ports blade, then select Add.
The Add facility window opens.
Step 4 Select the network facility (for example, CH-12-4-N).
Step 5 Select the desired wavelength from the Channel drop-down menu.
Step 6 Provision all required parameters according to your network plan.
Step 7 Select to add this channel.
Reconfiguring Wavelengths
To reconfigure the channel, perform these steps.
Step 1 Select .
Step 2 In the Navigation Tree, select Shelf > Channel module slot .
Step 3 Expand the Ports blade, then select the channel you wish to modify (for
example, CH-12-4-N).
The Configure Details window opens.
Step 4 Change the Admin State of the network facility to Maintenance.
Step 5 Select .
The Channel field is now accessible.
Step 6 Select the new wavelength from the Channel drop-down menu.
Step 7 Confirm with .
Step 8 Change the Admin State of the network facility to In Service.
FSP 3000R7 Maintenance and Troubleshooting Manual - Product Release 16.2 - Document Issue A 593