Standing Conditions
LPBKFACILITY (Loopback - Facility)
This condition is only possible when the entity is in an OOS-MT state, which will
suppress the autonomous reporting of this condition.
The corresponding SNMP name for this condition is “facilityLoopback”.
AIDTYPE Default
Severity
Probable Cause Suggested Corrective Action
CH NA A facility
loopback
operation is in
effect, forcing the
received signal to
be echoed on the
transmit direction
in place of the
normal signal.
A facility loopback operation is typically
performed as a part of service affecting
maintenance or testing activities. This
condition is informative and no
corrective action is needed.
ETH
Table 269: LPBKFACILITY (Standing Condition)
LPBKTERM (Loopback-Terminal)
This condition is only possible when the entity is in an OOS-MT state, which will
suppress the autonomous reporting of this condition.
The corresponding SNMP name for this condition is “terminalLoopback”.
AIDTYPE Default
Severity
Probable Cause Suggested Corrective Action
CH NA A terminal loopback
operation is in effect,
forcing the received
signal to be ignored and
replaced by the same
signal which is being
transmitted on this
facility.
A terminal loopback operation is
typically performed as a part of
service affecting maintenance or
testing activities. This condition is
informative and no corrective
action is needed.
ETH
Table 270: LPBKTERM (Standing Condition)
FSP 3000R7 Maintenance and Troubleshooting Manual - Product Release 16.2 - Document Issue A 889
To Next Page
Loading...
