Chapter 8 259
Bluetooth Signals
Using Burst
Using Burst
The steps in this procedure build upon the previous procedure.
1. Press
Return to return to the top-level Bluetooth menu.
2. Notice that
Burst Off On is set to On.
When burst is on, the signal power ramps up prior to transmitting the packet and then ramps down at the end
of the packet transmission. When burst is off, the transmitted packets link in a series with no power ramping.
The default burst setting is on, but for troubleshooting you may want to turn bursting off.
For this example burst is left in the on position.
Setting the Burst Power Ramp
This procedure builds upon the previous procedure.
Press
Burst Power Ramp > 4 > Symbols.
This sets the duration of the power ramp to 4 symbols prior to transmitting the first symbol of the packet.
To Next Page
Loading...
Need help?
General
