Chapter 2 23
E4438C Vector Signal Generator Overview
Calibration
NOTE If the PSG’s dynamic host configuration protocol (DHCP) is enabled, the network assigns
the instrument an IP address at power on. Because of this, when DHCP is enabled, the IP
address may be different each time you turn on the instrument. DHCP does not affect the
hostname.
12. Click
Browse, and double-click the firmware revision to upgrade your signal generator.
13. In the Upgrade Assistant, click
Next.
14. Once connection to the instrument is verified, click
Next and follow the on-screen prompts.
NOTE Once the download starts, it cannot be aborted.
NOTE When the User Attention message appears, you must first cycle the instrument’s power,
then click OK.
When the upgrade completes, the Upgrade Assistant displays a summary.
15. Click
OK and close the Upgrade Assistant.
Calibration
Agilent Technologies recommends calibrating the E4438C ESG Signal Generator every two years.
To Next Page
Need help?
General
